Echo EDR-210 Instrukcja Użytkownika

OPERATOR’S MANUALENGINE DRILLEDR-210X750-004 72 3X750409-3303ECHO POWER EQUIPMENT(CANADA)501 Newbold Street, London, Ontario Canada N6E 1K4 WARNINGR

8HANDLING FUELMIXING INSTRUCTIONS -1. Fill an approved fuel container with half of therequired amount of gasoline.2. Add the proper amount of two-stro

9STARTING COLD ENGINE• Stand the engine upright on a level surface.• Place ignition switch in ON (START/RUN)position.• Push purge bulb 3 to 4 times (o

10• This model is equipped with reverse rotationmechanism.• When drilling, set shift lever down to clockwise(CW) rotation position.• If bit is locked

11MAINTENANCE AND CAREIMPORTANTTime intervals are maximum. Actual use andyour experience will determine the frequencyof required maintenance.Record da

12TroubleEngine - hard to start Cause Remedy- does not startEngine Fuel at No fuel • Fuel filter clogged • Clean or replacecranks carburetor at carb

13MAINTENANCEAIR FILTER• Clean before use.- Remove air cleaner cover and pull out airfilter.- Lightly brush off dust or wash it in water anddetergent.

14Replacement of chuck should be done in thefollowing manner:1. Remove bolt with hexagonal hole fixed in thedriving axle.2. Insert accessory hexagonal

15STORAGE6. Drain the fuel tank completely and pull therecoil starter handle several times to removefuel from the carburetor.7. Remove the spark plug

16EDR-210Masswithout drill bit kg 4.6 (10.1 lbs )Volumefuel tank L 0.5 (16.9 US, fl. oz.)Drillsize mm 32 - 178 (1.25 - 7 inch)chuck capacity mm 13 (0.

This spark ignition system complies with Canadian ICES-002.Copyright © 2002 All Rights Reserved.

1 WARNINGIMPROPER USE OR CARE OF THIS UNIT, ORFAILURE TO WEAR PROPER PROTECTIONCAN RESULT IN SERIOUS INJURY. READAND UNDERSTAND THE RULES FOR SAFEOP

2 WARNINGALWAYS STOP THE ENGINE WHEN A DRILLJAM OCCURS. DO NOT ATTEMPT TOREMOVE AN OBJECT CAUSING A DRILLJAM IF THE ENGINE IS RUNNING. PHYSICALINJUR

3• Wear non-slip, heavy-duty work gloves toimprove your grip on the engine drill handles.The gloves also help reduce the transmissionof machine vibrat

4Repetitive Stress InjuriesIt is believed that over-using the muscles andtendons of the fingers, hands, arms and shouldersmay cause soreness, swelling

5 WARNINGBEFORE DRILLING, BE SURE TO READ ANDUNDERSTAND THE ENTIRE OPERATOR’SMANUAL TO AVOID THE CHANCE OFSERIOUS INJURY.• Do not force the drills a

6DESCRIPTION 1. Operator’s manual - Included with unit. Readbefore operation and keep for future referenceto learn proper, safe operating techniques.

7(Tighten three points evenly)Front handleWasherDrill bitChuckPlugASSEMBLINGFRONT HANDLEDRILL BIT• Insert the drill bit (not provided with unit) until